Mikado Logo 700 XXTREME - Assembly Electronics.

The kit comes with both 10mm and 12mm mountings, this is  to accommodate different servo widths between the rubber grommet mountings. I used KST BLS915 series servos which have 10mm mountings.
KST-BLS915 series servos have huge torque and precision under load. As verified from the factory, it also has no back EMF circuitry which is FBL unit friendly. These are very fast and high torque servos, that hold up the swash loads effortlessly during load tests and barely warm.

I will secure and thread lock the servo axial screws at a later time for VBAR FBL controller servo centering.

Soldering the electronics, the castle green 6.5mm connectors are rated for 160A and above. It is a non-spring type of connector that is suitable for high voltage applications.

linking up the electronics, i attach the servos as instructed by the Vbar control, the tail servo should be connected only after configuring the tail servo frame rate and pulse band. With the Vbar control RX, this freed up 4 additional empty ports for vbar power redundancy cables.